Page Comparison

If you have inserted a Dream Report USB license dongle into a USB port of your PC, wait for 1-2 minutes and if the red led LED on the tip of your USB key is not permanently on – that means, that within 1-2 minutes, it means the driver for the USB license dongle is not properly installed and you can install it , and should be installed manually.

 To install  To Manually Install the HASP driver manually, please, do the following:

1. Open a command prompt Command Prompt console (run cmd)

   Image RemovedImage Added

   
   Note:  In the following commands, change the driver letter\path to the appropriate location on your system, if different from the default

2. Remove existing HASP driver installations . To do so, please, - enter the following command:
   C:\ODS\Dream Report\Utilities\haspdinst.exe -kp -r
   

3. Install HASP driver . To do so, please, - enter the following command:

   C:\ODS\Dream Report\Utilities\haspdinst.exe -kp -i
   

4. Verify , that the existing HASP driver installations was successful . To do so, please, - enter the following command:
   C:\ODS\Dream Report\Utilities\haspdinst.exe -info

   In case, if If the USB license driver was successfully installed, you will see the version of the installed driver.  For example:
   

   Image Added